Home > UTV's >

Yamaha YXZ SE system



 
Alternative Views:


Our Price: $750.00

Product Code: 8-600-YXZ-LED
Qty:

Description
 

!!!! NOTE !!!! PCI radio not included

Features
:

• Eight circuits rated @30amps @12.5vdc per circuit that are “End-User” friendly terminal block for attaching accessories.

• Expandable (Daisy Chained selectable) to up to 32 circuits with simple plug-n-play features!

• Low voltage cutoff (LVCO) battery protection circuit has spec voltage cutoff at 11.2 VDC with a two-minute delay before shutting down the SourceSE. This is useful when you have accessories turned on while the vehicle is not running. When the vehicle starts, the accessories can then be used again. The low voltage battery protection circuit can be turned off with the DIP switches.

• No more worrying about what rated fuse to install! The system will protect from 1.5 amps to 30 amps automatically. The SourceSE incorporates a failsafe self-healing fault protection system. Fuses have been eliminated (for all accessory outputs) and replaced with current-sensing MOSFETs controlled by a microprocessor. This is a great feature for low maintenance and troubleshooting.

• Two circuits (switches 1 and 2) have the option to be activated by an ignition switched power source (great for accessories that you DO NOT WANT to turn on unless the ignition key is on). These two circuits can be easily changed to this option by a simple DIP switch setting on the SourceSE and running a jumper wire to tap into a fuse that is only activated when the ignition is on. The same two circuits can also be used as High-Beam activated circuits by tapping into the input side of one of the headlight’s high-beam circuits. We have taken care of the PWM issue with the headlight circuits.

• Shield receptacle for the optional Bluetooth module for a plug-n-play end-user upgrade. This creates a scalable platform for future optional enhancements such as Wi-Fi, Arduino, Raspberry Pi, special strobe interfaces, CANinterior bus integration to head units, intelligent circuit feedback and many other future options.


Switch Panel Features:

The new switch panel has 8 switches. This panel uses an Ethernet cable that interfaces with the Source with a RJ-45 plug on both ends. Standard cable length will be 10 feet.

• Each switch is programmable for (by a sequence of On/Off quickly ):

o Strobe

o Flash

• Automatic system shut down when panel is unplugged

• Dual lit (LED indicator lights, ON position & pilot light) in Red, Green, Blue or Amber single colors.

• Lower pilot light has an independent power control switch for full operator control

• Switches are Carling Technologies Contura series with an IP67 rating (marine/heavy equipment)

• Switch Panel housing is NOT plastic but rather, an aluminum formed and welded design to match the interior of the Jeep JK (2007 – 2015) with specific mounting hardware

• Switch panel can be daisy chained for remote operations (EG: one panel in cab and one panel in far back of truck) can easily add up to 10 switch panels. Options to mix and match with the Touchscreen panels as well

• Selection of up to 4 sPOD SourceSE to have control of up to 32 circuits.

• Two ports available integrated into the CAN-Bus controller.


Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

UTV's
-->